The new software enables active protection of the KOLIBRI’s electronic components during rapid load changes and avoids false overcurrent fault detection. New software V3.3 for the KOLIBRI models (HV-I and LV-I)
Note: When installing the new software V1.18 it can also be detected that the bootloader version is now set to 2.2 and the bootloader update was therefore successful. This completely replaces the bootloader update with firmware V1.18 and ensures that the bootloader update cannot activate itself again. Note: The bootloader update V1.1 updates the bootloader and does not contain any additional functions!Īfter the bootloader update V1.1, the new firmware V1.18 has to be uploaded to the KOSMIK as usual in the second step. IMPORTANT: Connect the motor and receiver.Ĭheck the version of the boot loader with ProgUnit: If V2.2 appears, the update has been completed successfully. Confirm here with “Yes” and perform the update.Īfter the update is finished, unplug the battery. ATTENTION: When starting the update, the error message will appear that the software is older than the software present on the KOSMIK. install the bootloader update V1.1 to the controller with the ProgUnit. The first step is to install the bootloader update on the KOSMIK 170/210/250/300 HV / HV-I:ġ. To avoid errors and malfunctions during the update, the update process must be carried out as described below. The update software automatically recognizes which KOSMIK variant is involved and writes the specific parameters to the KOSMIK during the update. the firmware for the KOSMIK 170/210/250/300 HV / HV-I are packed into one common update file.
Up to now, the KOSMIK had to be sent to the factory after an aborted update process with the bootloader adjustment, this is no longer necessary.Ĥ. the bootloader has been adapted so that the update can be restarted after an abort of an update process. – LED side: Mikado – BEC side: Jeti – Center: Futabaģ. The telemetry ports are assigned with the following protocols by default: adjustment of the current control: the sampling rate has been increased, thus the current peaks, which can lead to an overcurrent, are intercepted. In the firmware version V1.18 for the KOSMIK 170/210/250/300 HV / HV-I the following points have been added and improved:ġ.
0 kommentar(er)
